【摘 要】
：
Nowadays, in the auto industry, the need for improvement of fuel efficiency is getting increased more and more in terms of the global warming, as well as the ne
【机 构】
：
Daihatsu Motor Co.,Graduate School of Engineering University of Hyogo
论文部分内容阅读
Nowadays, in the auto industry, the need for improvement of fuel efficiency is getting increased more and more in terms of the global warming, as well as the need of light-weighting of gears, transmission parts. Hence, weve studied the relation between the shot peening working conditions and factors for improvement of gears fatigue life, and also the relation between the factors for improvement and the fatigue life, applying shot peening to a gear of SNCM220. Also, we examined the relation between the fatigue life and arc height that is utilized as a substitute characteristic for shot peening working conditions, adding its observation here.
其他文献
尽管这篇文章的故事略显零散，但是我们能够清晰地读懂作者所要表达的真情，一种源自内心的真情实感。这种真情来自平常的工作和生活，来自平时的细心观察和体会，情真意切。在相对朴
为了研究SiCw·SiCp/2024Al复合材料的热变形行为,对压铸法制备的SiCw·SiCp/2024Al复合材料进行了热挤压变形,并测定了其变形前后的室温拉伸性能.利用扫描电镜和透射电镜对
Closed Field Unbalanced Magnetron Sputter Ion Plating (CFUBMSIP) systems have been used increasingly for PVD coating in recent years. TiN and CrN coatings, comm
In the present work, attempts have been made to extend the use of the tribological and chemical properties of rutile-TiO2 to metallic alloy systems, by forming
A bath of electroless plating Ni on the AZ91D magnesium alloy, containing sulfate nickel, was given in this paper. The nucleation mechanism of Ni-P deposits on
This paper gives a short introduction to the typical process route and material properties of these steels in comparison to standard martensitic corrosion-resis
A reasonable pre-treatment and an ultrasonic pre-plating Cu film were applied for sintering NdFeB permanent magnet. The samples were then plated in neutral bath
Amorphous gels were processed with a varying Fe/Ba ratio of 11/5, 28/2, 10.5/1 in water and Solvent. Iron and barium nitrites with specific molar ratio was solv
The present work has investigated the effect of trace elements Cd and Sn on the microstructure and mechanical properties of Al-Si-Cu-Mg cast alloy. With the inc
In the present reserch, a model has been proposed for estimate fracture toughness of Nickel-phosphorus (EN) layers. For this purpose, high phosphorus (9%) EN co